Simple Way to Reset Oil Service indicator in Toyota Highlander




Maintenance Required Lamp/Indicator: Service and Repair
To reset the oil change system, follow the procedure below:
Vehicles without smart key system
Step 1:Set the engine switch to the "LOCK" position with trip meter A reading shown. Step 2:While pressing the trip meter reset button, set the engine switch to the "ON" position.
Vehicles with smart key system
Step 1:Set the "ENGINE START STOP" switch OFF with the trip meter A reading shown.
Step 2:While pressing the trip meter reset button, set the "ENGINE START STOP" switch to the IGNITION ON mode.
Step 3:
Note:
4.Input the conditions.
Without multi-information display: Continue to press and hold the button until the trip meter displays "000000". With multi-information display: Continue to press and hold the button until "COMPLETE" appears on the multi-information display.
Navigation Maintenance Item Setting (If equipped)
When the navigation system is turned on, the "Information" screen displays when it is time to replace a part or certain components.
1.Push the "INFO" button.
2.Touch "Maintenance"
3.Touch the desired button.
"Delete All": To cancel all conditions which have been input.
"Reset All" : To reset the item which has satisfied a condition.
If "ON" is selected, the system gives maintenance information with the "Information" screen when the system is turned on.
If "OFF" is selected, the "Information" screen is disabled.
When the vehicle needs to be serviced, the touch screen button color will change to orange.
Notice of "Date": The next maintenance date can be input.
Notice of "Distance": The driving distance until the next maintenance check can be input.
"Delete": To cancel the date and distance conditions.
"Reset": To reset the date and distance conditions.
5.Touch "OK" The screen returns to the "Maintenance" screen.
-For scheduled maintenance information, please refer to the Scheduled maintenance guide or Owners manual supplement.
-Depending on your driving or the road conditions, the system may have a time-lag between the data which has been input and the actual date and driving distance.

THANK YOU!

Share this

Related Posts

Previous
Next Post »